|
|
# R$ p- X" Q, T4 K- V7 Z, |
不確定是不是這個問題造成的，但可以參考一下這些資料。- N8 B( m# ~( b; I8 I7 W
) K* ^0 }: [8 {, b) ~
下面這段話是肥死卡好（Freescale）的技術文檔節錄下來的，講得一針見血、但內容較雜（ 不只討論這個問題），我給你另一篇 ATMEL 的技術文檔，它專門討論 MCU 的 Start-up Time，淺顯易懂、還有一些電路上的建議！
, ?9 C5 W$ {9 u' Q$ K7 p0 \2 \5 \$ f* y# c
Long Start-Up Time- P8 x. @; \: z) v, l) x
A long start-up time is usually a more common problem with low-frequency crystals, since they tend to start much more slowly than high-frequency crystals. One of the causes of a long start-up time is weak loop gain. Oscillator start-up times will also be affected by the rise time of the power supply. When the power supply has a sharp rise time, the crystal will experience an energy impulse that will usually make it start faster than it would using a power supply with a slow rise time.0 X1 z& P, T5 Q0 v* U0 x, n
! x# u8 g i' A8 h0 M 6 j- S6 S) n6 U' Y, v
|
|
/1 
发表于 2015-6-24 20:29
收藏
淘帖
支持！
反对！
发表于 2015-6-25 09:36
楼主
发表于 2015-6-26 08:42